June 22, 2006

Does anyone know the dimensions of a 1950 Chevy 1/2 ton front spindle versus a 3/4 ton front spindle? Any differences between the two? I've got a project 3/4 ton pickup and I'm wanting to maintain the solid front axle, but upgrade to front discs. The problem is, I've only found kits specified for a 1/2 ton pickup. Going to a 5-bolt wheel pattern isn't an issue, since the rear is going to be swapped also. I just need to know if a 1/2 ton conversion kit will fit the 3/4 ton spindle, or if I'll need to go another route.

Thanks

Eric

June 22, 2006

This is a good one for the guys at Classic Performance to answer for you. Check them out at http://www.classicperform.com/

June 23, 2006

check with rob at www.nolimit.net